Install details
Gas Pedal - GSR/LS assembly on left. ITR assembly on right
Remove (ie drill out spot welds) gas pedal actuator from both the GSR/LS brake/gas pedal bracket and the ITR brake/gas bracket. or, if you're lucky, swap the entire ITR assembly out and replace with GSR assembly. It's very tight in there though, steering column is really in the way.
here's a little detail
the bottom hole is the spot weld that was drilled out, with the new gas pedal assembly mounted on the existing brake/gas pedal bracket, the spot welds were replaced by bolts and lock washers.
Also shown is the small spot weld on the side that was drilled out.(above)
and installed, it pretty much looks like what you'd find under the dash of a integra equiped with cruise control except for the small bolt that appears where there prevoiusly was a spot weld.
but plan on laying on your floorboard like this for a while...
Wiring harness prior to install in car
New cable reel
quick comparison between the ITR cable reel and cruise control enabled cable reel.
Cruise control brain bracket
total pain in the ass to get the top bolt in.
Cruise Brain finally mounted. That big wire loom fights everything you try to do.
wiring up the actuator
Install new clutch switch
fab a bracket to hold the new cruise main switch
stealth install of said bracket
oem set/resume switches (sorry bout the glare)
Everything is installed and working properly, except for the indicator light in the gauge cluster... still working on finding one tiny part to get that operational. Scott's car is next, going to make him do all the bitch work this time.
D
